*USER MATERIAL

Define material constants for use in subroutine UMAT, UMATHT, VUMAT, or VUMATHT.

This option is used to input material constants for use in a user-defined mechanical model (user subroutine UMAT in Abaqus/Standard or user subroutine VUMAT in Abaqus/Explicit). In addition, it can be used to input material constants for use in a user-defined thermal material model (user subroutine UMATHT in Abaqus/Standard or user subroutine VUMATHT in Abaqus/Explicit).

Related Topics
In Other Guides
User-defined mechanical material behavior
User-defined thermal material behavior
UMAT
UMATHT
VUMAT
VUMATHT

ProductsAbaqus/StandardAbaqus/ExplicitAbaqus/CAE

TypeModel data

LevelModel

Abaqus/CAEProperty module

Required parameters

CONSTANTS

Set this parameter equal to the number of constants being entered.

Optional parameters

HYBRID FORMULATION

This parameter applies only to Abaqus/Standard analyses.

Set HYBRID FORMULATION=INCREMENTAL (default) to use an incremental Lagrange multiplier–based formulation with hybrid elements.

Set HYBRID FORMULATION=TOTAL to use a total Lagrange multiplier–based formulation with hybrid elements.

Set HYBRID FORMULATION=INCOMPRESSIBLE to define an incompressible material response with hybrid elements.

TYPE

Set TYPE=MECHANICAL (default) if the constants are used in defining the mechanical behavior of the material.

Set TYPE=THERMAL if the constants are used in defining the thermal constitutive behavior of the material.

If both the user-defined mechanical and the user-defined thermal behavior of the material are being modeled, the USER MATERIAL option should be repeated in the material data block such that each value of the TYPE parameter is used.

UNSYMM

This parameter applies only to Abaqus/Standard analyses.

Include this parameter if the material stiffness matrix, Δσ/Δε, is not symmetric or when a thermal constitutive model is used and f/(θ/x) is not symmetric. This parameter causes Abaqus/Standard to use its unsymmetric equation solution procedures.

Data lines to define material constants

First line
  1. Give the material constants, eight per line.

Repeat this data line as often as necessary to define all material constants.