Defining a connector moment

Display the connector moment load editor using one of the following methods:

• To create a new connector moment, follow the procedure outlined in Creating loads (Category: Mechanical; Types for Selected Step: Connector moment).

• To edit an existing connector moment using menus or managers, see Editing step-dependent objects. To edit the region to which the connector moment is applied, see Editing the region to which a prescribed condition is applied.

In the available M1, M2, and M3 text fields, enter the components of the moment for each available rotational component of relative motion (units FL). Only components common to all of the selected wires are available in the editor.

If you leave a text field blank, a moment of zero is assigned to that component of relative motion automatically. However, you must enter at least one nonzero component in the editor to define the load.

If desired, click the arrow to the right of the Amplitude field, and select the amplitude of your choice from the list that appears. Alternatively, you can click to create a new amplitude. (See The Amplitude toolset for more information.)

Click OK to save your data and to exit the editor.